Home Page

Pour On Gloss Coffee Table
Red gum burl grit blasted on top edge to remove sap, oxidation and bark from edges.

Duct tape applied to back to edge to prevent POG running away where holes go through.
NB:For large areas clamp or screw backing pieces under duct tape to support large areas as shown in fig 3&4

 Place burl on level surface to fill holes in top face.

Fill holes using a syringe with a draw up needle for small holes. Pour into larger holes.
NB:Our detailed instructions contain alot more info on achieving a trouble free finish.

Work on one area at a time. When holes almost full, use an open flame to burst bubbles.
NB:More details in our instructions.

 Remove the support and duct tape from the underside of burl.
Course sand 40 to 60 grit both faces using a belt sander or random orbital sander to remove lumps & bumps and all gloss. Fill all holes and hollows around the edge using the techniques shown. Fill all holes and hollows around the edge using the techniques shown.
  Print this page Next Page
DRIVE Marine Services provides Good Quality products at a reasonable price
BIAMember BEVERLY HILLS NSW  2209
(02) 9533 5470 		Bote.Cote@optusnet.com.au
This site is © Drive Marine Services 2008, All Rights Reserved